11
$\begingroup$

enter image description here
(Source)

Wikipedia says:

After [the Ryan XV-5 Vertifan demonstrated] that large amounts of air could be moved through a lift fan, an 80 in (2.0 m) tip drive fan turned through 90 degrees, driven by a more powerful J79 engine, was built to demonstrate an efficient cruise fan. The concept of a large diameter cruise fan was incorporated in the General Electric TF39 engine, used on the Lockheed C-5 Galaxy.

Was the XV-5 responsible for ushering in the high-bypass concept?

The economic drive is discussed here:

I'm more after the evolution of the engineering concept I think, i.e., the different iterations and studies—a brief history lesson.

Improve this question
$\endgroup$
2
  • $\begingroup$ I have no citable source, but bypass engines were already planned before the end of WWII. The technical advantages were known, only the poor efficiency of jet engines at that time made them unrealistic. The XV-5 had nothing to do with the development of high-bypass engines. $\endgroup$
    – Peter Kämpf
    Commented Feb 17, 2017 at 20:30
  • $\begingroup$ Thermodynamics probably by analogy with compounding (and triple expansion) in steam engines, and later (ca 1900) compound steam turbines. $\endgroup$
    – user_1818839
    Commented Oct 25, 2021 at 14:50

1 Answer 1

Reset to default
11
$\begingroup$

The need for a turbofan was realized as early as the mid-30s.

The first jet aircraft were subsonic and the poor suitability of the propelling nozzle for these speeds due to high fuel consumption was understood, and bypass proposed, as early as 1936 (U.K. Patent 471,368). The underlying principle behind bypass is trading exhaust velocity for extra mass flow which still gives the required thrust but uses less fuel. Whittle called it "gearing down the flow".

In the mid-60s, the USAF A-X and CX-XX programs accelerated the development of the high-bypass jet engines. The winners of the programs were the Fairchild Republic A-10 Thunderbolt II and the Lockheed C-5 Galaxy, respectively.

To meet the [CX-XX] power and range specifications with only four engines required a new engine with dramatically improved fuel efficiency.

The TF39 on the C-5 Galaxy was the first production high-power, high-bypass jet engine. It first ran in 1964. The XV-5's lift-fan-inspired-demonstrator helped confirm to GE the feasibility of high-bypass jet engines.

The demonstrator was the GE1/6 (cruise fan variant), it featured a GE1 core engine energizing remote tip-turbine-driven cruise fan of high-bypass. (Sadly, I can't find photos/illustrations.)

Around the same time the Convair 990 Coronado was powered by the CJ805-23, which featured one of the first aft-mounted fans.

enter image description here
(Source) CJ805-23 with the aft-fan.

Transatlantic service needed a higher thrust version of the existing turbojet and a demonstrator engine with a single-stage front fan attached to the compressor was run. It was difficult to start and operate. This experience led to the aft-fan which didn't compromise the operation of the gas generator.

For its time, the TF39 had unique features—namely the 1½ fan-stage—which resulted in an impressive 8:1 bypass ratio, higher figures were seen only decades later on the Boeing 777's GE90.

enter image description here
(Wikimedia) TF39.

The front of the engine features a mini-fan that rotates inside stationary vanes. Behind this first ½ stage is a full-sized fan. A fair proportion of the air entering the ½ stage is also ducted to the bypass stream.

enter image description here
(FLIGHT International, 13 March 1969)

The two-spool high bypass General Electric CF6 (top half section) is based on the same gas generator and turbine as the TF39 (bottom section) which powers the Lockheed C-5A Galaxy.

The mostly civilian and much simpler CF6 was based on the T39, it is found on the Airbus A300/310/330, Boeing 747/767, DC-10/MD-11, and others.

Honorable mentions

Two years before the A-X program, Avco Lycoming was working on the earliest experimental turbofans, but not necessarily high-bypass. With development and various derivatives contributing to the Lycoming ALF 502 which powered the Northrop YA-9 entry for the A-X program.

enter image description here

enter image description here
(FLIGHT International, 10 February 1972)

The only production fan engine to use an aft-mounted fan is the CF-700, power unit of the Fanjet/Mystere 20.

enter image description here
(Source)

Sources: Various issues of FLIGHT, Wikipedia, and The Power to Fly: An Engineer's Life.

Improve this answer
$\endgroup$

You must log in to answer this question.