Questions tagged [aircraft-structures]

For structural engineering questions about airframes and the mechanical structures aboard aircraft

6 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
4
votes
0answers
532 views

How much does a Boeing 737 wing bend/deflect in cruise conditions?

As a part of my ongoing research of a structural joint analysis of a Boeing 737, I have been looking for sources where I may be able to find the bending/deflection data during cruise conditions. I ...
2
votes
1answer
95 views

How do I find the shear center of an unsymmetrical airfoil?

I'm quite a newbie of these systems and I am designing the wing box of a drone. I know where I want my shear centre. However, I have been trying to determine the shear centre of my idealized airfoil. ...
1
vote
0answers
56 views

Texts on aero-engine structures

I have been scouring the web for resources on aero-engine structures and structural design (preferably civil turbofans) but unfortunately it seems like they are hard to come by. I would like dedicated ...
1
vote
0answers
110 views

How do I reinforce a tubular spar that has been drilled vertically for an attachment bolt?

Previously posted a question about lift strut attachment to tubular wing spar with a bolt vertically through the spars. See drawing below. I tried using Bruhn's analysis book to formulate a a ...
1
vote
0answers
45 views

Is TGA analysis required for composites used in low speed subsonic aircraft?

I need to analyse the temperature drop effects on glass-fiber reinforced polymer (GFRP) used in aircraft subjected to icing, how can it be done? Does thermogravimetric analysis (TGA) help or is it ...
0
votes
0answers
40 views

Why is the assumed Lift-to-Weight-Ratio for the limit drop test for heavy aircraft (FAR-25) higher than for small aircraft (FAR-23)?

The FAR-25.725 assumes a Lift-to-Weight-Ratio L/W = 1 for the landing gear drop test while the FAR-23.725 assumes only L/W=0.667. This factor affects the load inertia factor n which is also needed for ...