15 questions linked to/from What is the performance of a flat plate wing?
350 views

### Why aren't compressor and turbine blades flat? [duplicate]

Why are the compressor and turbine blades of a jet engine shaped as airfoils? Why can't they be flat?
44k views

### What is the method to calculate a finite wing's lift from its sectional airfoil shape?

I am struggling to get my head around a concept that I believe should be fairly simple to understand. Lift versus drag and AoA data of many airfoils are freely available, for instance the NACA 4-...
• 2,038
3k views

### How would an airfoil react if it was flown backwards?

Out of curiosity what would happen? Would pressure on both top and bottom flip? or stay the same or act as a normal wing with less lift? I'd assume it would still take longer to travel over the top ...
• 1,103
13k views

### How do symmetrical airfoils generate lift? [duplicate]

It is widely understood that the curved shape of a typical airfoil (such as a Clark Y) causes a pressure difference that creates lift. How do symmetrical airfoils do this when the top and lower ...
• 5,699
2k views

### Why does a flat plate create less lift than an airfoil at the same AoA?

This picture of the lift curve slopes for four-digit NACA airfoils and a flat plate is from another question on this topic. It shows that at the same positive AoA, a flat plate generates less lift ...
• 415
815 views

### Why are there two local maximums on some CL vs AOA curves?

I know what a stall is but I don't understand why there are in some cases two local maximums on the $C_L$ vs AOA curve of some airfoils. What is the reason for the mini stall that occurs before the ...
1k views

### Why does stalling increase drag?

I understand (I think) why lift reduces in a stall. What I don't understand is why drag increases. I can see that the ratio of drag to lift would increase, but I'm not sure I understand the mechanism ...
• 169
3k views

### Is the angle of attack equal to zero when the plane is on the ground with wings level?

I read in the internet that when an airplane stands at the airport (horizontal) it has zero degree aoa. The captain must pitch up the plane during cruise to generate an amount of lift and when the ...
2k views

### How to calculate drag of a flat rectangular surface at given area, air density, airspeed and angle of attack?

I'm a complete noob in aerodynamics, and I'm trying to calculate the drag of a rectangular flat area, given the air pressure / density, area, angle of attack and airspeed. I've read this question, but ...
• 1,394
430 views

### What is formula for induced drag in stalling regime?

I'm wondering what is the formula for induced drag in a stalled regime, i.e. in a regime where the $C_L$ (coef. of. lift) has started to decrease but is still nonzero. I've a feeling that the ...
• 223
606 views

### Is it possible to maintain horizontal flight with the angle of attack above critical value by increasing speed?

In this video a stall happens at 1:40 upon reaching the critical angle of attack. The air flow is now detached from the upper part of the wing, resulting in higher pressure above the upper part of the ...
• 1,019
512 views

### What would be the power requirements and performance of a Scroggs-type delta-wing aircraft with a 250 cm span?

Roy Scroggs, a tailor, patented in 1917, US1250033, and in 1932 US1848578, a Delta Wing plan form machine 'Flying Dart', flight tested with an OX-5 engine, they say ...
• 1,631
1 vote
235 views

### Lift Coefficient question

I am making a RC Airplane, it has a wing profile as shown above. What might be the approx. lift coefficient of this? The wingspan is 80cm, what will the lift provided be by this wing at 65kmph ?
• 43