1 vote
467 views

### How do you determine the lift coefficient of a finite wing using the coefficient of an infinite one? [duplicate]

How assuming I know the lift coefficient of an airfoil/infinite wing, how do I then use this value to calculate the lift coefficient of a finite wing? Please quote your sources. Many thanks,
88 views

### What are some features of a wing, which effects its lift coefficient other than its sectional view? [duplicate]

What geometrical features of a lifting surface apart from which airfoil it has, I mean the ones visible from the top and front view of a wing (for ex: its span, AR, sweep, dihedral etc.) effects its ...
• 467
17k views

### Is a winglet better than an equal span extension?

Is there indisputable evidence that a winglet improves performance over an equal span extension? Please note: I am only interested in L/D improvements. Winglets do improve roll performance, that is ...
• 232k
10k views

### What is ground effect?

We've all heard the "acts like a cushion of air" explanation tossed casually around by CFIs. There's also plenty of books and reference materials that give a detailed, accurate, and complete ...
• 23.2k
39k views

### What is the performance of a flat plate wing?

By flat plate I mean this: Source: Physics.SE Low performance indeed, but how much low? How would: The angle of attack, The speed range, The turn capability, The fuel consumption, Or other ...
• 73.5k
6k views

### Why is the coefficient of drag for straight wings at supersonic speeds lower than for swept wings?

Why is the coefficient of drag of a straight wing lower than the coefficient of drag of a swept back wing at higher supersonic speeds (above, say, Mach 2)?
• 1,452
8k views

### How does the angle of attack vary in turns?

I read somewhere that when the aircraft banks to turn, its angle of attack increases.Since angle of attack is the angle between the relative wind and chord line, how does turning increase it? Is it ...
• 2,359
2k views

### Is there a parameter that links the areas of the fuselage and control surfaces? [closed]

Do aircraft designers look at the ratio of how much fuselage surface area can be loaded onto a given unit of wing and tail surface area including elevator, aileron, rudder etc? (Possibly, the surfaces ...
• 1,035
2k views

### Why do delta wings generate less lift at a particular angle of attack compared to straight wings?

I simulated a delta wing and a straight wing in xflr5 with the same profile, wing area and airspeed (very low airspeed. around 10 m/s. it's for a model aircraft). The straight wing was operating at ...
777 views

### How much does the fuselage of an airplane contribute to yaw stabilization?

Obviously considering that (almost) every plane has a vertical stabilizer, probably not, but for a relatively long aircraft does the fuselage measurably contribute to the yaw stabilization relative to ...
3k views

### Why stall on 2D faster than 3D?

why cl on 2D is better than 3D. and why cl 2D stall faster than 3D? what happens when CP continues to move forward on the wing. and what happens when CP continues to move forward on the elevator.
1k views

### How to trim in level flight when speed increases?

What is required to happen to control surfaces and trim tabs to remain trimmed in straight and level flight, as speed increases? (for a GA propelled aircraft) My manual tells me that the elevator ...
• 265
1k views

### Why are the aerodynamic characteristics of a finite wing different from the properties of its airfoil section?

Why are the aerodynamic characteristics of a finite wing different from the properties of its airfoil section?
2k views

### How does rudder size influence its ability to produce lateral lift?

Does anyone know how the area, height and width of a rudder affect how well it provides lateral lift? I've heard that the most effective rudders are around 35% of the vertical stabiliser MAC but is ...