20
$\begingroup$

If you have an airship filled with helium, how can you adjust your altitude? i.e. how do you "go up" or "go down"?

Even staying still would be a challenge: The way I see it, you'll never have exactly the same average density as air and therefore will always be either slightly falling or slightly rising.

Is it the case that they have an extra tank of compressed gas as well as vents on the blimp and they make adjustmenst by increasing/decreasing internal pressure of the balloon?

$\endgroup$
26
$\begingroup$

An airship pilot has three ways of adjusting lift:

  1. Every lighter-than-air vehicle needs some ballast to adjust its weight. This could be sand, but mostly water is used.

  2. A blimp is only partially filled with helium. The envelope is held taut by filling a bag inside with air, called a ballonet. If you press a little more air in this bag, the overall density of the gasses in the envelope goes up, while the volume stays practically constant. This allows for fine adjustment. Forward and aft ballonets even allow for trimming the pitch attitude.

  3. When the airship moves, the air does provide a little dynamic lift or downforce, depending on pitch attitude and elevator deflection. This is a little tricky, because airships are not stable, and a pitch-up command will lead to altitude loss below a critical speed.

enter image description here

The ballonets in this cutaway drawing of a Goodyear blimp are numbered 2 and 4.

On a calm day, the biggest disturbance is actually the sun. If the envelope is exposed to direct sunlight, it will heat up and the gas within will be heated as well, causing the blimp to rise. If the sun is covered by a cloud, the gas cools down and loses some lift. On partially cloudy days it is not easy to keep the same altitude!

Another threat is an unstable atmospheric temperature gradient. Glider pilots love this, because it will give them strong thermals, but the gas inside the airship will behave similarly to that bubble of warmer gas which causes thermals. When the airship rises, the gas inside cools less quickly than the surrounding air, and the airship will gain lift when it goes up. It becomes really bad on the way down: Now the gas warms up less quickly as well, and the airship loses lift as it comes down. The airship pilot needs to drop some ballast or create more dynamic lift, or his craft will slam into the ground.

Long-range airships like the LZ-127 used a mixture of hydrocarbon gases as fuel. This mixture (called Blaugas) was balanced to be just as heavy as air and filled some of the gas cells within the envelope. Consumed fuel would be displaced by air, so no lift adjustment was needed on a long trip.

$\endgroup$
  • 2
    $\begingroup$ According to a CarTalk (US radio program) puzzle, during World War II the Germans invented a condenser which would capture from the exhaust of burning gasoline a mass of water roughly equal to the mass of fuel burned. I wonder if that concept would still be practical? $\endgroup$ – supercat Sep 9 '14 at 23:07
  • 1
    $\begingroup$ @supercat: The last Zeppelins were wrecked in 1940 - so that was way before WW II. Yes, that technique was indeed used on gasoline-powered long-range Zeppelins, and it would be practical if blimps would travel at higher speeds and for longer durations. Today, fuel consumption is not high enough to make the additional mass of the condenser system worthwhile. $\endgroup$ – Peter Kämpf Sep 10 '14 at 7:43
  • 1
    $\begingroup$ Epic answer, thanks man! $\endgroup$ – CaptainCodeman Sep 10 '14 at 11:01
  • 1
    $\begingroup$ @DavidRicherby: Thank you for the editing! I knew something was looking odd with that word, but I couldn't tell what it was. $\endgroup$ – Peter Kämpf Sep 10 '14 at 19:20
4
$\begingroup$

Inside the airship are ballonets that are filled with air. These can be easily inflated with compressor and deflated to outer atmosphere without wasting the precious lifting gas, especially in the new designs where the lifting gas is usually safe but expensive helium.

In non-rigid and semi-rigid ships the ballonets are inside the gas cell. In rigid ships the ballonets were between the gas cells and were together with them constrained by the outer shell.

There are normally at least two ballonets, fore and aft, to provide pitch control.

As for altitude control, airships are actually stable in altitude. As the ship ascends, the shell does not allow the gas to expand as fast as the outer pressure declines, therefore reducing buoyancy. Of course as fuel is burnt, weight decreases and the pressure needs to be adjusted accordingly to maintain altitude. Many airships also have swivelling engines allowing additional up or down thrust.

$\endgroup$

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.