Take a look at the yellow parts which are mounted on the wing of an Embraer ERJ-145. What is it?



Two closer images:



From bottom:

enter image description here


They are called vortilons. They can induce a vortex to the upper surface of the wing at high angles of attack, which allows flying at higher angles of attack before stalling.

Additionally, four vortilons were installed on the lower surface leading edge of the outboard wing panel. Their interaction with the wing sidewash at high angles of attack produce strong vortices that are convected to the upper surface, where they modify the pressure distribution and boundary layer development, postponing flow separation and increasing maximum lift. Their shape and position were defined using the 3D panel program. The combined effect of the leading edge droop and vortilons allowed an improved take-off and landing performance without resorting to more complex variable geometry leading edge devices (such as slats), for a small cruise performance penalty. Figure 22 shows a schematic representation of the ERJ145 droop and vortilon.

ERJ145 wing

(The evolution of the aerodynamic design tools and transport aircraft wings at Embraer)

They were first used on the Douglas DC9. The original patent shows the vortex on the upper side of the wing:

Vortilon with vortex

  • 2
    $\begingroup$ +1 for mentioning LE droop. This can be seen in the lowest picture of the question. Droop adds more to the maximum lift coefficient than vortilons do. $\endgroup$ – Peter Kämpf Nov 26 '20 at 17:11

They are Vortilons, a type of vortex generator. The placement of the vortilon low on the leading edge limits its vortex generation to high angles of attack (where the air meeting it is going over the top of the wing), and at low angles of attack, it's just a little fin sticking out, not creating too much drag (but not none).

They are used to improve aileron control at low speed, and/or stall behaviour where the effects aren't necessary at high speed. They are definitely a "band-aid" added to fix a problem that came up during cert testing. You generally don't add projecting bits like that unless you have to.

  • $\begingroup$ "You generally don't add projecting bits like that unless you have to" - winglets, tail-fins, huge rotating awacs radomes, pitot tubes, etc $\endgroup$ – Dai Nov 28 '20 at 2:57
  • 3
    $\begingroup$ A winglet is not rally a projecting bit. It's a sail that provides thrust and weakens the circulation with its outwash so there is a net gain. The other bits you mention, are there... because they have to be, for one reason or another. If designers could measure dynamic pressure for airspeed without a pitot sticking out, they would. If AWACs could do its job without the radome, it would. if Embraer could have tamed it's low speed aileron control problem without vortilons, at a manageable cost, it would have. $\endgroup$ – John K Nov 28 '20 at 3:59

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.