For airliners, under which meteorological conditions is de-icing required?

What factors (temperature, humidity, dew point, precipitation, etc.) influence the decision to de-ice?

Is decision to de-ice down to regulations, the airline, or the captain?

  • $\begingroup$ Are you asking about in-flight use of deicing systems, or deicing prior to takeoff? The regulations and decision making processes differ between the two scenarios. $\endgroup$
    – J W
    Feb 17, 2017 at 23:12

2 Answers 2


There are a few stages where ice prevention or mitigation is relevant. The FAA publishes a nice handbook on it here if you want more info. Very broadly speaking De-Icing activated when airframe ice is noticed. Anti-Ice is activated when a Pilot believes they may enter icing conditions. Ground based De-Ice is applied when icing conditions prevail in the area.

Before Takeoff

Most, if not all commercial airports offer de-ice facilities if geographically relevant. After the crash of Air Florida 90 the FAA took a bit of a harder stance on De-Ice and now stresses the need for mobile De-Ice units to allow planes to be De-Iced without leaving the taxi queue as well as permanent stations as they have always had. A lot of their suggestions are covered in this AC as well as this one. In this case both airline procedure and FAA regulations will dictate the need for De-Ice. Strictly speaking according to FAR 121.629 a dispatcher can hold an aircraft if they feel it is not correctly De-Iced. However by the same law a pilot can hold their own departure for the same reason.

En Route

Once in the air there are a few ways things happen, but generally its ultimately up to the pilot to activate the De-Ice system. On one hand the aircraft POH will more than likely have guidance on when to do this, however, airlines may implement further (and more strict) procedures. Some aircraft are equipped with systems that automatically activate in the presence of ice build up.

Once in route there are effectually two kinds of systems,

  • Anti Ice: prevents the build up of ice in the first place, heated leading edges etc. These are activated before entering icing conditions.
  • De-Ice systems: like boots these systems remove ice once its built up. In this case you need to actually enter the conditions and allow the ice to build up first.

Ice can form in a variety of conditions and can be dangerous or potentially fatal in some aircraft. The temperature depends on the cloud type but generally speaking low temperature and higher moisture content will create worse issues.
enter image description here (source)

Pilots will be alerted to possible icing conditions via an AIRMET ZULU. These are often quite broad area AIRMET's. If a pilot believes they are potentially flying into icing conditions they should keep an eye on the airframe for structural icing build up. Many airplanes have icing lights to help at night with this. A pilot can activate the De-Ice system at any point if they feel it is needed.

  • 3
    $\begingroup$ Per §121.629 the flightcrew must not takeoff if the aircraft needs to be deiced. This is a regulatory requirement, not an option. $\endgroup$
    – J W
    Feb 17, 2017 at 23:17

For all aircraft, structural icing can occur when moisture is present in the air at temperatures between about 4° and -10°C.

Your comments would indicate you are talking about the application of deciding fluid to the aircraft prior to departure. The inidividual airlines may have their own protocol for the use of deciding fluid, but the decision to do so is the prerogative of the flight crew with the captain's approval. Most likely that kind of decision is made if known icing conditions are anticipated in the flight plan immediately after takeoff. A proper weather briefing for AIRMET sierras, temp/dew point spreads, IMC conditions with precipitation and low temperatures present all would factor in to this decision.

  • 1
    $\begingroup$ The decision on whether or not to de-ice is the flight-crew's to make, but that decisionmaking process is defined by 14 CFR, Operation Specifications, and approved company manuals, and must be accomplished in accordance with an approved ground deicing/anti-icing program. $\endgroup$
    – J W
    Feb 17, 2017 at 23:19

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .